3/4 HP 115V SUBMERSIBLE UTILITY DRAINER PUMP 6.4A 15′ 18/3 GROUNDING CORD STAINLESS W/ OPTIONAL USE FLOAT SWITCH AND ADAPTERS INCLUDED STARITE

3/4 HP 115V SUBMERSIBLE UTILITY DRAINER PUMP 6.4A 15′ 18/3 GROUNDING CORD STAINLESS W/ OPTIONAL USE FLOAT SWITCH AND ADAPTERS INCLUDED STARITE

The new sturdy PCD-1000TM Submersible Pump can pump water down to 1 3/8 inches in depth and is intended for utility and draining applications. The pump has a superior stainless-steel impeller, shaft, suction strainer, and casing for increased corrosion resistance and longer service life, along with increased flow rates. The pump can handle stones and debris up to 3/4 inches in diameter. For quicker drainage, the pump has a 1 1⁄4-inch discharge outlet. Additionally included are discharge port adapters and a float switch.

Automatic Reset Thermal Protector

The PCD-1000™ Submersible Pump is equipped with an automatic reset thermal protector to help prevent premature failure caused by overheating. The motor will be protected by the switch, which will cause it to stop if the internal motor temperature reaches dangerous levels. The switch will automatically reset and restart the motor after it has cooled down enough to allow you to start pumping again.

Float Switch

The PCD-1000 pump can optionally operate automatically thanks to the integrated external float switch. Connecting the pump wire to the switch’s other end and plugging it straight into an outlet makes installation simple. When the surrounding water causes the float switch to rise to a 45° angle from the handle, the pump is then automatically turned on. The pump shuts off automatically when the float switch and water level return to their initial positions.

Highlights: 

•    115V, 60 Hz, single phase, permanent split capacitor motor.
•    Automatic thermal overload protection.
•    Clog-resistant cast stainless steel impeller.
•    Accommodates water temperatures ranging from 32°F to 130°F.
•    Permanently lubricated ball bearings.
•    Equipped with 15-foot, 18/3 grounding-type power cord.
•    Convenient, top-mounted handle.
•    Rubber feet to eliminate scratching

SPECIFICATIONS:

Model: PCD-1000

HP: 3/4

Motor Full Load (Amps): 6.4

RPM: 3450

Minimum Circuit Requirement: 15 amps

Liquid Temperature Range: 32/130°F-0/54°C

Switch Setting On-12″ (30 cm); Off- 6″ (15.2 cm)

Pumps Down To: 1 3⁄8″ (3.5 cm)

Pump Performance TDH/GPM
5′: 45.5
10′: 34.0
15′: 21.5
20′: 12.0
Shut Off Head- 26.2′-N/A

WHAT’S IN THE BOX:

1 x Pentair PCD-1000™ Submersible Stainless Steel Utility Pump